BWT BC50 Manual De Usuario página 7

Note: Clean the filter regularly. Too much debris inside the filter will increase burden to
the motor operation and then shorten the operating duration.
To re-position the transparent canister (with the filter cone inside) to the rear body, make
sure the locking knob on both sides is turned to the unlock position. Align the raised arch
on both sides of the transparent canister with the locking knobs and then turn the knob
clockwise until it points to the red marking to secure the assembly.
Attention: The case has one correct position only. The water-draining valve must be
facing the bottom when holding the cleaner horizontally by the handle.
FACT: Rechargeable lithium-Ion battery is classified as a consumable item. It has a limited life
and will gradually lose its capacity to hold a charge. Therefore, running time of the pool vacuum
will gradually reduce through repeated charging and discharging in operation.
Once the lifespan of the battery reaches its end, refer to section "BATTERY DISPOSAL" for
instructions regarding battery disposal
NOTE: Let the pool vacuum rest for 30 to 40 minutes before charging it again.
Set-Up Before Use
Handle assembly
Insert the handle into the pool vacuum as shown, until the side pin on the handle is
secured to the handle's locking hole on the rear body.
To release the handle, press down on the side pin and pull out the handle.
6/175