Publicidad
Idiomas disponibles
Idiomas disponibles
Preparing the appliance before use
In the event of the indoor and outdoor
units being disconnected for a long
period of time, protect the free end of
the hose against dirt and dust by
fitting the protection cap (See Fig 23).
Before connecting the two parts
again, it is recommended that you
clean any dirt which has built up on
the indoor unit connection with a
clean, dry cloth.
Important!
To prevent the risk of refrigerant loss,
we do not recommend that the hose
be left disconnected from the indoor
unit for more than one day. Never
operate the indoor unit without the
outdoor unit.
Joining the flexible hose to the
indoor unit
Connect the flexible hose back onto the
indoor unit by following the steps
described above in reverse order.
If the rubber cap is fitted on the free end
of the hose, remove it and position it as
shown in Fig. 24 before fitting the entire
assembly onto the indoor unit.
Fig. 22
Important!
The hose has only one assembly
position.
Make sure that the lever is secured by
safety tab A, Fig. 21. Only then is the
connection correct.
Make sure that the electrical
connection is covered by the cover
and secured with the relevant screw.
Fig. 19A.
Make sure that the water tube is fitted
properly to prevent water from
Fig. 23
dripping onto the support surface. To
do this, follow the indications shown
in Fig. 20 in reverse order.
46
Fig. 24
Publicidad
