Publicidad
Idiomas disponibles
Idiomas disponibles
Instructions for Use
Function
air conditioning
In this function, the appliance reduces
ambient temperature until the desired
temperature is reached. The appliance
dehumidifies and purifies the air in the
room at the same time in order to create a
pleasant atmosphere.
To do this
• Lift the air director on the top of the
appliance and, if you wish, open the side
fins manually, see A and L, Fig. 1 for
enhanced air distribution within the
room. It is recommended that these air
outlets be left fully open or fully closed in
order to prevent unpleasant noise.
• On models with disconnectable hose,
check that the hose, the electrical
connection and the water tube are
properly connected to the indoor unit.
• Make sure that plugs N, Fig. 1 and C,
Fig. 2, are in their housings to prevent
water from leaking onto the support
surface.
• Plug the appliance into the mains
electricity supply.
• Select the maximum
conditioning function, Fig. 25. (The silent
air conditioning function reduces the air
flow on the appliance).
Fig. 25
• Select the desired temperature, Fig. 26.
If the appliance turns itself off
automatically because the desired
temperature for the room has been
reached, it will not start working again
until ambient temperature rises 2-3°C.
Fig. 26
• Finally, make sure that the flexible hose
If the "full" indicator light, Fig. 3 lights up
having followed the installation instructions
properly, then make sure that there is no
water in the appliance. If there is, empty it,
Fig. 7. The light will go out.
Condensed water normally evaporates
through the outdoor unit. If there is too
much water, it may not be possible to
expel it all. If this happens, it accumulates
on the base of the outdoor unit and may
drip. Do not worry, this is normal. Simply
or silent
air
place a receptacle beneath nozzle C Fig.
2, and remove the accumulated water.
Important!
Remember that when the appliance is
turned off, it is necessary to wait for
approximately 3 minutes before
turning it back on again. This period of
time is required in order to ensure
correct appliance operation.
Function
In this operation function, the appliance
reduces the humidity in the atmosphere.
The appliance purifies the air in the room
at the same time in order to create a
pleasant atmosphere.
• Check that there is no water in the
47
which joins the two units is not crushed
or restricted, that the difference in
height between the units does not
exceed 1.5 m, Fig. 11, and that the
outdoor unit is not lower than the indoor
unit, Fig. 12.
dehumidification
outdoor unit by removing plug C, Fig. 2.
Put it back in position after extracting the
water.
Publicidad
