Publicidad
Idiomas disponibles
Idiomas disponibles
Instructions for Use
• Transport the outdoor and indoor units
to the room you wish to dehumidify. See
Transportation requirements.
• Place a bowl at the drainage pipe outlet
and remove the plug to collect the
condensed water from the indoor unit.
Fig 7.
• Plug the appliance into the mains
electricity supply.
• Set the thermostat to its minimum
temperature setting. Fig. 27.
Fig. 27
• Lift the air director on the top of the
appliance. You are also recommended to
open the side fins manually, see A and
L, Fig. 1. Water may accumulate on the
surface of the side fins if they are not
fully open or fully closed. In order to
prevent water from dripping onto the
floor, it is recommended that the side
fins be left either fully open or fully
closed. Unpleasant noise may also be
prevented in this way.
• Select the dehumidification function on
the function control knob. Fig. 28.
Fig. 28
Important!
The amount of water dehumidified
may vary depending on ambient
conditions (See Appendix).
Do not forget to replace the plug onto
the drainage pipe when you change
function, otherwise the appliance will
shed water when operated.
Remember that ambient temperature
must be 18ºC or higher in order for the
appliance to work.
In this operation function, room
temperature rises slightly.
Function
air purification
The air inside the room (ventilation) is
circulated through a filtering system when
the appliance is set to this function.
The appliance comes with a basic filter
(already fitted on the appliance) and a
purifying filter (except on models with
permanent connection) to be fitted by the
user (See "Fitting the purifying filter")
against:
– Pollen, bacteria and dust.
• Plug the appliance into the mains
electricity supply.
• Lift air director A, Fig. 1. It is
recommended that you open side air
outlets L, Fig. 1 manually. These should
be left fully open or fully closed to
prevent unpleasant noise.
• Set the purification speed: maximum
or silent
, Fig. 29.
Fig. 29
The use of the purifying filters (optional on
models with permanent connection) is
especially indicated in order to achieve
greater purifying efficiency when using the
dehumidification and air purification
functions.
48
Publicidad
