Nebula Mars II Instrucciones De Seguridad página 3

to a warm area; b) after a cold room is heated; c)
when the device is placed in a damp room. To avoid
any moisture, seal the device in a plastic bag before
moving it to another room, and wait for one to two
hours before you take it out of the bag.
Power Supply
Use only the provided power adapter.
•
Power off the device before removing the power supply
•
from the socket.
• Protect the power cord from being walked on or
pinched, particularly at plugs, convenience receptacles,
and the point where they exit from this device.
Unplug this device if there are lightning storms or
•
when unused for a long period of time.
Where the power plug or an appliance coupler is used
•
as the disconnect device, the disconnect device shall
remain readily operable.
Before you make or change any connections, ensure
•
that all devices are disconnected from the power outlet.
Never touch the power cable or the power connector
•
with wet hands.
Hearing Safety
To avoid hearing damage, do not listen for extended
•
periods at high volume. Set the volume at a safe level.
Battery
Do not replace the built-in battery yourself. Contact an
•
authorized service center to replace it.
The remote control contains coin type batteries which
•
can be swallowed. Keep the batteries out of reach of
children.
Risk of explosion! Keep batteries away from heat, direct
•
sunlight, or fire. Never discard batteries in fire.
When the remote control is not used for a long period
•
of time, remove the batteries.
There is a danger of explosion if the battery is
•
incorrectly replaced. Replace only with the same or
equivalent type.
• Batteries contain chemical substances, they should
be disposed of properly.
02
Charge the device regularly. Do not store the device
•
with a completely discharged battery.
Cleaning
Power off the device and remove it from the power
•
supply before cleaning the surface.
Use a soft, lint-free cloth. Never use liquid, gaseous,
•
or easily flammable cleansers (like sprays, abrasives,
polishes, and alcohol).
• Do not use any liquid cleaning agents to clean the lens
as they may damage the protective coating on the lens.
Wipe over the surfaces gently. Be careful that you do
•
not scratch the surfaces.
Use lens cleaning paper to clean the lens of the
•
projector.
Repairs
• Do not make any repairs to the device yourself. Only have
your device repaired by an authorized service center.
Improper maintenance can result in injuries or
•
damage to the device.
Refer all servicing to qualified service personnel.
•
Class II equipment symbol
This symbol indicates that the unit has a double insulation
system.
Laser Safety
CLASS 1
LASER PRODUCT
IEC 60825-1:2014. Complies with IEC 62471:2006 Risk Group 2.
Caution:
Possibly hazardous optical radiation emitted from this
•
device.
Do not stare at operating beam. The bright light may
•
hurt your eyes.
03