Futurelight DJ-HEAD 250 WASH Manual Del Usuario página 30

Controlling:
After having addressed all DJ-HEAD 250 WASH, you may now start operating these via your lighting
controller.
Note:
After switching on, the DJ-HEAD 250 WASH will automatically detect whether DMX 512 data is received or
not. If the data is received, the control LED flashes. If there is no data received at the DMX-input, the control
LED lights up permanently.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of DJ-HEAD 250
WASH.
- the controller is switched off or defective.
- the cable or connector is defective or the signal wires are swap in the input connector.
Note:
It's necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to
ensure proper transmission on the DMX data link.
DMX-protocol 16 Bit-resolution
Control-channel 1 - Horizontal movement (Pan) (within 530°)
Push slider up in order to move the head horizontally (PAN).
Gradual head adjustment from one end of the slider to the other (0-255, 128-center).
The head can be stopped at any position you wish.
Control-channel 2 - Vertical movement (Tilt) (within 280°)
Push slider up in order to move the head vertically (TILT).
Gradual head adjustment from one end of the slider to the other (0-255, 128-center).
The head can be stopped at any position you wish.
Control-channel 3 - Pan-movement with 16 Bit-resolution
Control-channel 4 - Tilt-movement with 16 Bit-resolution
Control-channel 5 - Pan/Tilt-speed
Decimal Hexad. Percentage S/F
0 0 00 00 0% 0%
1 249 01 F9 0% 98%
250 252 FA FC 98% 99%
253 255 FD FF 99% 100%
Control-channel 6 - Reset
Decimal Hexad. Percentage S/F
0 199 00 C7 0% 78%
200 209 C8 D1 78% 82%
210 255 D2 FF 82% 100%
S Maximum speed
F Decreasing speed
S Maximum speed (tracking mode)
S Maximum speed (vector mode), black-out while Pan, Tilt moving
S No function
S Reset
S No function
30/64
Feature
Feature
00026432.DOC, Version 1.2