Publicidad
Idiomas disponibles
Idiomas disponibles
Warm
This function will maintain an oven temperature of
170 °F. The Warm function will keep cooked food
warm for serving up to three hours after cooking has
finished. The Warm function may be used without any
other cooking operations.
Setting the Warm Function
1
Turn the oven mode knob to select Warm.
2
Press Start.
3
Turn the oven mode knob to the Off position
when warming is finished.
nOTE
• The Warm function is intended to keep food
warm. Do not use it to cool food down.
• It is normal for the fan to operate during the
Warm function.
Proof
This feature maintains a warm oven for rising yeast
leavened products before baking.
Setting the Proof Function
1
Use rack position 2 or 3 for proofing.
2
Turn the oven mode knob to select Proof.
3
Press Start.
4
Turn the oven mode knob to the Off position
when proofing is finished.
nOTE
• To avoid lowering the oven temperature and
lengthening proofing time, do not open the oven
door unnecessarily. Check bread products early
to avoid over proofing.
• Do not use the proofing mode for warming
food or keeping food hot. The proofing oven
temperature is not hot enough to keep foods
at safe temperatures. Use the Warm feature
to keep food warm. Proofing does not operate
when the oven is above 125 °F. Hot shows in
the display.
• It is normal for the fan to operate during the
Proof function.
remote Start
If the appliance is registered on a home Wi-Fi
network, this function starts preheating and then
holds the temperature for up to an hour (including
preheating time). If the appliance is not registered on
the network, "OFF" appears in the display. Follow the
instructions on page 40 to register the appliance on
the network.
Set the oven mode knob to the Remote Start position
to use the function.
For Model : LSG4513
Setting remote Start
1
Open the oven door to make sure the oven is
empty and ready for pre-heating. Close the oven
door.
2
Within 30 seconds of closing the door, turn the
oven mode knob to select Remote Start. If more
than 30 seconds passes before you initiate
Remote Start, "door" appears in the display. If
this occurs, open and close the door and try
again.
3
When ON appears in the display, the Remote
Start function is ready to use.
4
Follow the directions in the smart phone
application to set the cook mode, temperature,
and run time (preheating time plus holding time).
nOTE
Do not place food in oven before or during
Remote Start run time.
Remote Start is disconnected in the following
situations:
• Remote Start is never set up in the smart phone
app.
• The Remote Start status is "OFF" or "door".
• Remote Start experiences a problem during
operation.
• The Remote Start function cannot be started
when the oven door is open. A beep alerts you
to shut the door.
OPERATION
39
For Model : LSG4511
Publicidad
