Maintenance; Idle Speed Adjustment - Maruyama M LINE MT23L Manual Del Propietário

Trimming
Hold the bottom of the trimmer head about 3 in. (7.6
cm) above the ground and at an angle. Allow only the
tip of the line to make contact.
Scaling
To remove unwanted vegetation, hold the trimmer head
about 3 in. (7.6 cm) above the ground and at an angle.
Allow the tip of the line to strike the ground cutting the
vegetation off at the surface.
Mowing
Keep the line parallel to the ground and use a gentle
side-to-side motion.
Three inches
(7.6cm)
Above Ground
Three inches
(7.6cm)
Above Ground
— US-16 —

Maintenance

Maintenance, replacement or repair of emission
control devices and systems may be performed by
any repair establishment or individual; however,
warranty repairs must be performed by a dealer or
service center authori zed by MARU YAMA
Manufacturing Company, Inc. The use of parts that
are not equivalent in performance and durability to
authorized parts may impair the effectiveness of the
emission control system and may have a bearing on
the outcome of a warranty claim.
Maintenance on today's low-emission engines is
even more critical for longest life and best perfor-
mance. particularly critical are air and fuel filters,
spark plug heat range, cooling air intake area and
proper gaps of coil and plug.

Idle Speed Adjustment

This Trimmer is equipped with non-adjustable fuel
mixture carburetor. The engine idle speed is the only
adjustment for the operator.
WARNING
• Idle speed adjustment should be
checked each time the unit is operated.
WARNING
POTENTIAL HAZARD
• Engine must be running to make carbu-
retor adjustments.
• When engine is running, cutting head is
rotating and other parts are moving.
WHAT CAN HAPPEN
• Contact with rotating cutting head or
other moving parts could cause serious
personal injur y or death.
HOW TO AVOID THE HAZARD
• Keep hands, feet and clothing away from
attached tool and other moving parts.
• Keep all bystanders and pets away from
unit while making carburetor adjust-
ments.