Assembly; Loop Handle Installation; Installing Debris Shield - Maruyama M LINE MT23L Manual Del Propietário

Assembly

Loop Handle Installation

Screw (4)
Nut (4)
1. Place the loop handle and the bottom clamp on the
shaft approximately 11 inches (28cm) from the
end of the stop switch/throttle trigger assembly
for an inital handle position.
2. Install the four screws and nuts. Leave the screws
finger-tight.
3. Reposition the loop handle up or down the drive
shaft to the most comfortable position, but no
closer than 9 inches (22.8 cm) from the end of the
stop switch.
4. Tighten the screws and nuts.
Loop Handle
Bottom Clamp
— US-9 —

Installing Debris Shield

WARNING
POTENTIAL HAZARD
• Foreign objects can be thrown by String
Trimmer.
WHAT CAN HAPPEN
• Contact with thrown objects can cause
personal injury.
HOW TO AVOID THE HAZARD
• Never operate the String Trimmer with-
out the debris shield in place.
CAUTION
POTENTIAL HAZARD
• The String cutoff blade is sharp.
WHAT CAN HAPPEN
• Contact with cutoff blade could cause
serious cuts or personal injury.
HOW TO AVOID THE HAZARD
• Keep hands, feet and clothing away
from cutoff blade.
1. Fasten the string cutoff blade to the debris shield
with two M5 x 15 screws and hex nuts.
M5 x 30
Screw (2)
Gearcas
Plate
Hex Nut (2)
String Cutoff Blade
2. Attach the debris shield to the gearcase with the
two M5 x 30 screws and plate as shown.
Shaft
Debris Shield
M5 x 15
Screw (2)