Cutting With Trimmer Head - Maruyama M LINE MT23L Manual Del Propietário

Recortadora
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3.
The operator's right hand should be holding the
shaft grip, with his or her fingers on the throttle
trigger. The right arm should be slightly bent.
4.
The left hand should be holding the loop handle
with the fingers and thumb fully enclosed around
the grip. The left arm should be extended.
Reposition the loop handle up or down the drive-
shaft if necessary for a comfortable position.
5.
The Trimmer weight should be evenly distributed
between the arms. The trimmer head should be
near and parallel to the ground.
6.
Accelerate and hold the engine at cutting speed
before entering the material to be cut.
7.
Always release the throttle trigger and allow the
engine to return to idle speed when not cutting.
8.
Stop the Trimmer engine when moving between
work sites.
CAUTION
• Always wear gloves and protective cloth-
ing when operating the String Trimmer.
• If the trimmer head becomes jammed, stop the
engine immediately.
• Make certain all moving parts have stopped and
disconnect the spark plug before inspecting the
equipment for damage.
• Never use a String Trimmer that has chipped,
cracked or broken trimmer head.

Cutting with Trimmer Head

• The tip of the line does the cutting. The line
should stay extended while cutting.
Three inches
(7.6 cm) Above
Ground
• Do not force the line into the material. Forcing the
line will cause it to slap against the material,
increasing line usage and causing poor cutting
results.
— US-15 —
CORRECT
INCORRECT

Publicidad

Tabla de contenido
loading

Tabla de contenido