Haier HSU-09LEK13/R2 Manual De Operación página 6

Operation
Timer On/Off On-Off Operation
1.After unit starts, select your desired operation mode.
TIME
2.Press / TIME
ON
OFF
Every time the button is pressed, display changes as follows:
Remote controller:
TIMER ON
0.5h
TIMER ON
TIMER OFF
0.5h
TIMER ON
Then select your desired TIMER mode (TIMER ON or
TIMER OFF ). " "or "
TIME
3.Press / TIME
ON
OFF
Press the button for each time, setting time in the first
12 hours increased by 0.5 hour every time, after 12
hours,increased by 1 hour every time.
4.Confirm timer setting
After adjust the time,press
time ON or OFF button will not flash any more.
5.Cancel timer setting
Press the timer button by times until the time display
eliminated.
Hints:
After replacing batteries or a power failure happens, time
setting should be reset.
According to the Time setting sequence of TIMER ON or
TIMER OFF, either Start-Stop or Stop-Start can be
achieved.
4
button to change TIMER mode.
BLANK
BLANK
"will flash.
button to set time.
button and confirm the
Health airflow Operation
1.Press to starting
Setting the comfort work conditions.
2.The setting of healthy airflow function
Press button to select " Healthy airflow", the remote
controller will switch as below
Healthy
airflow
upwarder
Notice: Do not direct the flap by hand. Otherwise, the
grille will run incorrectly. If the grille is not run correctly,
stop for a minute and then start, adjusting by remote
controller.
Note:
1.After setting the healthy airflow function, the position
grill is fixed.
2.In cooling, it is better to select the
3.In cooling and dry , using the air conditioner for a long
time under the high air humidity, condensate water may
occur at the grille .
Healthy
fixed
airflow
location
downwarder
mode.