Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALL THE DUCTWORK
(DUCTED HOODS ONLY)
NOTE: To reduce the risk of fire, use only
metal ductwork.
1. Decide where the ductwork will run
between the hood and the outside.
2. A straight, short duct run will allow the hood
to perform most efficiently.
3. Long duct runs, elbows, and transitions
will reduce the performance of the hood.
Use as few of them as possible. Larger
ducting may be required for best performance
with longer duct runs.
4. Install a roof or wall cap. Connect round
metal ductwork to cap and work back
towards hood location. Use duct tape to
seal the joints between ductwork sections.
SPACING BAR INSTALLATION
To compensate possible depth voids between
the appliance and the wall, a plastic SPACING
BAR to be fixed at the back of the appliance
by means of the three screws (3.9 x 6 mm) is
included. The 3 screws to be used are
contained in the accessory bag attached to
the plastic spacing bar.
Cut the spacing bar according to the distance
to be adjusted.
FIGURE 1
HOOD
24" TO 30" ABOVE
COOKING SURFACE
FIGURE 2
MOUNTING SCREWS
(3.9 x 6 mm)
- 5 -
ROOF CAP
6"
ROUND DUCT
ROUND
ELBOW
WALL
CAP
Publicidad
