Publicidad
Idiomas disponibles
Idiomas disponibles
CONNECT DUCTWORK
(DUCTED HOODS ONLY)
1. Install the discharge collar into the duct
connector of the range hood. Fig. 7
2. Use 6" round metal duct to connect the
discharge collar on the hood to the
ductwork above. See Fig. 8
3. Use duct tape to make all joints secure
and air tight.
4. Insert the unit plug into the power outlet.
FIGURE 8
Ø 6"
ROUND
METAL
DUCT
NON-DUCTED
RECIRCULATION FILTER
INSTALLATION
(NON-DUCTED HOODS ONLY)
1. Install the discharge collar into the duct
connector of the range hood. Fig. 7
2. Refer to Figure 8B. Connect a 6" round
metal duct to the discharge opening so
that the air is sent outside the cabinet and
sent back into the room.
3. Position the filters over the blower.
4. Rotate to lock filters in place.
5. Purchase replacement filter packs
(contains 2) from your dealer.
Part No. FILTEREB40.
FIGURE 7
FIGURE 8B
Ø 6"
ROUND
METAL
DUCT
FIGURE 9
- 8 -
DISCHARGE
COLLAR
DUCT
CONNECTOR
CHARCOAL
FILTERS
Publicidad
