Orbegozo TL 07160 BL Manual De Instrucciones página 12

TL 07160 BL/IN/MA
INSTALLATION
If you have an air outlet to the outside, your hood can be connected as the figure
below with a pull-out tube.
Way one:
1. The cooker hood should be placed at a distance of 65-75cm from the
cooking surface for best effect.
2. To install onto the wall drill 4 holes of 8mm diameter on a suitable place
according with the centre distance of hole in the back of the cooker hood.
3. Insert the nut into the holes.
4. Insert the screws into the nuts and tight them.
5. Put up the cooker hood onto the fixed screws.
Way two:
1. Drill 6 holes of 4mm of diameter at the bottom of the hanging cupboard.
2. Put the one way valve on the cooker hood, then install the cooker hood on the bottom of the
cupboard, tighten the hood with enclosed 6 screws.
3. Install the adjusted board on the bottom of the hood in order to keep out the gap between hood
back and cupboard.
OPERATION
1. Connect the plug into the power.
2. Push the switch 1 into
Push the switch 2 into "I" to select low speed or to "II" to select high speed; "0" position the
3.
motor will switch off.
The cooker hood will work at low or high speed when you pull out the front panel.
4.
position, the lamp will be on; push into "0" to switch off the lamp.
12