Speaker Leads; Power Amp (Sold Separately) - Pioneer AVH-X7700BT Manual De Instrucciones

Connection
9 Blue/white
Connect to system control terminal of the power amp (max.
300 mA 12 V DC).
a Light green
Used to detect the ON/OFF status of the parking brake. This
lead must be connected to the power supply side of the
parking brake switch.
b Power supply side
c Parking brake switch
d Ground side

Speaker leads

1
2
L
3
5
7
F/H
8
6
R/M
c
Perform these connections when using a subwoofer without the
optional amplifier.
48
f
SW
1 To power supply
2 Power cord
3 Left
4 Right
5 Front speaker (STD) or high range speaker (NW)
6 Rear speaker (STD) or middle range speaker (NW)
7 White
8 White/black
9 Gray
a Gray/black
b Green
R
c Green/black
4 d Violet
e Violet/black
f Subwoofer (4Ω)
9
g When using a subwoofer of 70W (2Ω), be sure to connect the
a
subwoofer to the violet and violet/black leads of this unit. Do
not connect anything to the green and green/black leads.
h Not used.
d
i Subwoofer (4Ω) × 2
e When a subwoofer is connected to this product instead of
a rear speaker, change the rear output setting in the initial
setting. The subwoofer output of this product is monaural.
 Switching the rear speaker output on page 38
With a two-speaker system, do not connect anything to the
speaker leads that are not connected to speakers.

Power amp (sold separately)

Without internal amp
Important
The speaker leads are not used when this connection is in
use.
L R
3 4
d
c e
g
d
h
c
e
1
2
5
2
1
7
i
2
1
9
With internal amp
Important
Front speaker and Rear speaker signals (STD) or middle range
speaker and high range speaker signals (NW) are output from
the speaker leads when this connection is in use.
1
2
9
1 System remote control
Connect to Blue/white cable.
2 Power amp (sold separately)
3 Connect with RCA cable (sold separately)
4 To Rear output (STD)
To middle range output (NW)
5 Rear speaker (STD)
Middle range speaker (NW)
6 To Front output (STD)
To high range output (NW)
7 Front speaker (STD)
High range output (NW)
8 To subwoofer output (STD)
To low range output (NW)
9 Subwoofer (STD)
Low range speaker (NW)
Change the speaker mode to standard mode (STD) or net-
work mode (NW).
3
4
5
3
6
7
3
8
9
3
8
9