Notice For The Blue/White Lead; Rear Panel (Main Terminals); Power Cord; Speaker Leads - Pioneer AVH-Z9250BT Manual De Instrucciones

• For connecting a power amp or other
devices to this product, refer to the
manual for the product to be connected.
• The graphical symbol placed on
the product means direct current.
Notice for the blue/
white lead
• When the ignition switch is turned on
(ACC ON), a control signal is output
through the blue/white lead. Connect to
an external power amp's system remote
control terminal, the auto-aerial relay
control terminal, or the aerial booster
power control terminal (max. 300 mA 12
V DC). The control signal is output
through the blue/white lead, even if the
audio source is switched off.
Important
When this product is in [Power OFF] mode,
the control signal is also turned off. If
[Power OFF] mode is cancelled, the control
signal is output again and the aerial is
extended with the auto aerial function (if
the aerial is being used). Be careful so that
the extended aerial does not come into
contact with any obstacles.
54
En
Rear panel (main
terminals)
GPS aerial 3.55 m
Microphone 3 m
RGB cable (supplied with Hideaway TV
tuner)
This product
Hideaway 1 seg digital TV tuner (GEX-
2850DVB2 (sold separately))
Aerial jack
AV cable IN/OUT
Power supply
Fuse (10 A)
Wired remote cable
Hard-wired remote control adapter can
be connected (sold separately).

Power cord

WARNING
IMPROPER CONNECTION MAY RESULT IN
SERIOUS DAMAGE OR INJURY
INCLUDING ELECTRICAL SHOCK, AND
INTERFERENCE WITH THE OPERATION
OF THE VEHICLE'S ANTILOCK BRAKING
SYSTEM, AUTOMATIC TRANSMISSION
AND SPEEDOMETER INDICATION.
To power supply
Power cord
Yellow
To terminal supplied with power
regardless of ignition switch position.
Red
To electric terminal controlled by
ignition switch (12 V DC) ON/OFF
Orange/white
To lighting switch terminal.
Black (earth)
To vehicle (metal) body.
Violet/white
Of the two lead wires connected to the
back lamp, connect the one in which
the voltage changes when the gear shift
is in the REVERSE (R) position. This
connection enables the unit to sense
whether the car is moving forwards or
backwards.
Pink
Car speed signal input
Blue/white
Connect to system control terminal of
the power amp (max. 300 mA 12 V DC).
Light green
Used to detect the ON/OFF status of the
handbrake. This lead must be
connected to the power supply side of
the handbrake switch.
Power supply side
Handbrake switch
Earth side
NOTE
The position of the speed detection circuit
and the position of the handbrake switch
vary depending on the vehicle model. For
details, consult your authorised Pioneer
dealer or an installation professional.

Speaker leads

Perform these connections when using a
subwoofer without the optional amplifier.
To power supply
Power cord
Left