Power Cord; Speaker Leads - Pioneer DMH-A5450BT Guia De Inicio Rapido

This product
GPS aerial 3.55 m
Microphone 3 m
This product
Aerial jack
Connector 1 (REAR VIEW CAMERA IN/
MUTE/STEERING WHEEL CONTROL)
Connector 2 (AUX IN)
Pre out supply
Fuse (10 A)
Power supply
To connector 1
SWC/Back Camera cord
Wired remote input (STEERING WHEEL
CONTROL)
Hard-wired remote control adapter can
be connected (sold separately).
Brown (REAR VIEW CAMERA IN)
Yellow/black (MUTE)
8
En

Power cord

To power supply
Power cord
Yellow
To terminal supplied with power
regardless of ignition switch position.
Red
To electric terminal controlled by
ignition switch (12 V DC) ON/OFF
Orange/white
To lighting switch terminal.
Black (earth)
To vehicle (metal) body.
Violet/white
Of the two lead wires connected to the
back lamp, connect the one in which
the voltage changes when the gear shift
is in the REVERSE (R) position. This
connection enables the unit to sense
whether the car is moving forwards or
backwards.
Pink
Car speed signal input
Blue/white
Connect to system control terminal of
the power amp (max. 300 mA 12 V DC).
Light green
Used to detect the ON/OFF status of the
handbrake. This lead must be
connected to the power supply side of
the handbrake switch.
Power supply side
Handbrake switch
Earth side
NOTE
The position of the speed detection circuit
and the position of the handbrake switch
vary depending on the vehicle model. For
details, consult your authorised Pioneer
dealer or an installation professional.

Speaker leads

To power supply
Power cord
Left
Right
Front speaker
Rear speaker
White
White/black
Grey
Grey/black
Green
Green/black
Violet
Violet/black
NOTE
With a two-speaker system, do not connect
anything to the speaker leads that are not
connected to speakers.