Publicidad
Idiomas disponibles
Idiomas disponibles
Working Advice
• For marking, always use only the center of the laser line. The width
of the laser line changes with distance.
Working with the Tripod (Accessory)
A tripod offers a stable, height-adjustable measuring support. Position
the measuring tool with the 1/4" tripod mount 10 onto the thread of the
tripod or a commercially available camera tripod. For fastening to a
commercially available construction tripod, use the 5/8" tripod mount
11. Tighten the measuring tool with the tripod mounting stud.
– Adjust the tripod before switching on the measuring tool.
Fastening with the Positioning Device (Accessory)
(see figure H)
With the positioning devices 16, 17, 21, you can fasten the measur-
ing tool, e.g., to vertical surfaces, pipes or magnetizable materials.
The positioning device is also suitable for use as a ground tripod and
makes the height adjustment of the measuring tool easier.
– Adjust the positioning device 16, 17, 21 before switching on the
measuring tool.
Working with the Laser Target Plate (see figure H)
The laser target plate 24 increases the visibility of the laser beam
under unfavorable conditions and at long distances.
The reflective part of the laser target plate (located in the center of the
plate) improves the visibility of the laser line. Thanks to the transpar-
ent strip, the laser line is also visible from the back side of the laser
target plate.
-29-
2610041780 6-18 GLL100G.indd 29
6/8/18 7:14 AM
Publicidad
