Publicidad
Idiomas disponibles
Idiomas disponibles
4.
Installation preparation
Unpack installation materials and accessories.
To improve allocation to the work steps, the packages are
identified differently.
To do this, comply with the overview sheet attached to the
appliance!
5.
Preparing the installation cavity
WARNING
Assure that there are no electrical wires or plumbing in
the area which the screws could penetrate.
Risk of injury and damage!
NOTE
– 2 anti-tip-angles are required for each appliance.
– The supplied set contains fastening screws for
various applications. Select the fastening screws
according to the local conditions.
The anti-tip-angles must have a minimum length of 4
(105 mm) over the appliance to ensure a secure stand of the
appliance.
If this minimum length cannot be observed for structural
conditions it is possible to do this by fastening a spacer
behind the anti-tip angle, e. g. a sufficiently dimensioned
wood plank.
All manuals and user guides at all-guides.com
1
/
"
8
The length of the plank should correspond to the width of the
installation niche!
Specify the attachment points of the anti-tip-angles.
̈
Specify the detailed dimensions according to the section
on "Installation dimensions".
Attach the anti-tip-angles completely. Be sure screws
̈
hold tight.
Fastening with wood screws
13
Publicidad
