EINHELL TH-ID 550/1 Manual De Instrucciones Original página 26

5. Before starting the equipment
Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
Warning!
Always pull the power plug before making
adjustments to the equipment.
5.1 Fitting the drill bit (Fig. 2)
•
Open the chuck (1) by turning it anti-clockwi-
se with the supplied chuck key (6)
•
Open the chuck (1). The drill bit opening must
be large enough to fit the drill bit into.
•
Select a suitable drill bit. Push the drill bit as
far as possible into the chuck opening.
•
Close the chuck (1) by turning the chuck key
(6) clockwise until the drill bit or tool is secure.
Check that the drill bit is secure in the chuck
(1).
•
Check at regular intervals that the drill bit or
tool is secure (pull the mains plug).
6. Operation
6.1 ON/OFF switch (Fig. 3/Item 4)
•
First fit a suitable drill bit into the tool (see
5.1).
•
Connect the mains plug to a suitable socket.
•
Position the drill in the position you wish to
drill.
To switch on:
Press the ON/OFF switch (4)
Continuous operation:
Secure the ON/OFF switch (4) with the locking
button (3).
To switch off :
Press the ON/OFF switch (4) briefl y.
6.2 Clockwise/Counter-clockwise switch
(Fig. 3/Item 5)
•
Change switch position only when the drill is
at a standstill!
•
Switch the direction of the hammer drill using
the clockwise/counter-clockwise switch (5):
Direction
Clockwise (forwards and drill)
Anleitung_SA_TH_ID_550_1_SPK8.indb 26 Anleitung_SA_TH_ID_550_1_SPK8.indb 26
GB
Counter-clockwise (reverse)
6.3 Drill / hammer drill selector switch
(Fig. 4/5 Item 2)
Change switch position only when the drill is at a
standstill!
Drill
Drill / hammer drill selector switch (2) in the drill
position. (Position A)
Use for: Wood, metal, plastic
Hammer drill
Drill / hammer drill selector switch (2) in the ham-
mer drill position. (Position B)
Use for: Concrete, rock, masonry
6.4 Tips for working with your hammer drill
6.4.1 Drilling concrete and masonry
•
Switch the Drill/Hammer drill selector switch
(2) to position B (Hammer drill).
•
Always use carbide drill bits and a high speed
setting for drilling into masonry and concrete.
6.4.2 Drilling steel
•
Switch the drill / hammer drill selector switch
(2) to position A (drill).
•
Always use HSS drill bits (HSS = high speed
steel) and a low speed setting for drilling
steel.
•
We recommend that you lubricate the hole
with a suitable cutting fluid to prevent unne-
cessary drill bit wear.
6.4.3 Inserting/ Removing screws
•
Switch the Drill/hammer drill selector switch
(2) to position A (drill)
•
Use a low speed setting
6.4.4 Starting holes
If you wish to drill a deep hole in a hard material
(such as steel), we recommend that you start the
hole with a smaller drill bit.
6.4.5 Drilling tiles
•
To start the hole, switch the drill / hammer drill
selector switch (3) to position A (drill).
•
Switch the drill / hammer drill selector switch
(3) to position B (hammer drill) as soon as the
drill bit has passed through the tiles.
Switch position
Pushed in to the
right
- 26 -
Pushed in to the
left
08.02.2018 08:48:13 08.02.2018 08:48:13