Publicidad
Idiomas disponibles
Idiomas disponibles
Prepare the Hood
1 ] If present, remove all protective polyfilm from the hood and/or parts.
2 ] Remove 7" Round Duct Plate from top/back of hood (see illustration below). Keep the screws
3 ] Using the finger cup, remove the grease filters from the hood by pushing down
4 ] Using a 11/32" nutdriver or socket, remove the lock nut retaining the flange of the right cover
10
for further use.
7" ROUND
DUCT PLATE
2 SCREWS
filters out
.
plate (shaded part on illustration below) to the inner back of hood (see inset). Remove the
right cover plate retaining screws (7 screws), then set the blower cover along with its screws
and nut aside.
B
C
5
4
6
1
7
BACK OF HOOD
LOCK NUT
and tilting
3
2
Publicidad
