Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
Always turn your hood on before you begin cooking to establish an air flow in the kitchen.
Let the blower run for a few minutes to clear the air after you turn off the range. This will help
keep the whole kitchen cleaner and fresher.
This hood is equipped with infrared sensing controls. To activate it, simply touch the sensor
corresponding to the desired function and/or intensity. At the touch of the sensor, a beep is
emitted to acknowledge the command.
MASTER ON/OFF
Touch this sensor to turn ON the lights and blower at the last saved blower and/or lighting level.
When the blower and/or lights are ON, touching this sensor will store the last-used blower speed
and light intensity and turn the unit off.
BLOWER
ACTIVATION/SPEED CHANGE
When blower is OFF, touch the sensor corresponding to the desired blower speed. The sensor will
illuminate and the blower will activate.
When the blower is ON, touch the sensor corresponding to the active blower speed to turn the
blower OFF and memorize the blower speed.
NOTE: When LOW speed is activated from OFF, the blower starts on MEDIUM speed for a very
short moment, and then resumes to LOW speed.
DELAY OFF
To activate the Delay OFF function, while the blower is ON, touch and hold for 3 seconds the
illuminated sensor corresponding to the active blower speed. A beep will be emitted at the first
touch, and again at the end of the 3-second hold. The blower will continue to operate for 10 minutes
at this setting. During this time, the sensor corresponding to the active blower speed will blink to
indicate that the Delay OFF function was activated.
When the Delay OFF function is activated, the blower speed can be changed by touching the
sensor corresponding to the desired blower speed without affecting the remaining time of the delay.
To cancel the Delay OFF function before the end of the 10-minute cycle, touch and hold for
3 seconds the sensor corresponding to the active blower speed, or simply touch the Master ON/OFF
sensor.
HEAT SENTRY™
This hood is equipped with a protective device that changes the blower speed when an abnormally
high heat level is detected while the blower is activated. When the Heat Sentry is activated, it sets
the blower on MEDIUM speed while all the blower sensors blink. The lighting can still be controlled,
but the blower will remain on MEDIUM speed until the heat level is normal. The blower will then
return to the speed previously selected.
NOTE: When excessive heat is detected, Heat Sentry will shut off both the blower and lights
while all the blower sensors will blink faster. Both the blowers and lights will remain OFF
until the temperature cools down; the blower will then start on MEDIUM speed and the
lights can be controlled again. The blower will remain on MEDIUM speed until the heat
level is normal. The blower will then return to the speed previously selected.
5
Publicidad
