Publicidad
TROUBLESHOOTING
T T h h e e T T V V d d o o e e s s n n o o t t o o p p e e r r a a t t e e p p r r o o p p e e r r l l y y . .
The remote control
does not work
Power is suddenly
turned off
T T h h e e v v i i d d e e o o f f u u n n c c t t i i o o n n d d o o e e s s n n o o t t w w o o r r k k . .
No picture &No sound
Picture appears slowly
after switching on
No or poor colour
or poor picture
Horizontal/vertical bars
or picture shaking
Poor reception on
some channels
Lines or streaks
in pictures
No picture
when connecting HDMI
All manuals and user guides at all-guides.com
Check to see if there is any object between the TV and the remote control causing
A
an obstruction. Ensure you are pointing the remote control directly at the TV.
Ensure that the batteries are installed with correct polarity (+ to +, - to -).
A
Ensure that the correct remote operating mode is set: TV, VCR etc.
A
Install new batteries.
A
Is the sleep timer set?
A
Check the power control settings. Has the Power supply been interrupted.
A
Is Auto sleep activated on this station?
A
Check whether the TV is switched on.
A
Try another channel. The problem may be with the broadcast.
A
Is the power cord inserted correctly into the mains?
A
Check your antenna direction and/or location.
A
Test the mains outlet by plugging another TV into the same outlet.
A
This is normal, the image is muted during the TV startup process. Please contact
A
your service centre, if the picture has not appeared after five minutes.
Adjust Colour in menu option.
A
Allow a sufficient distance between the TV and the VCR.
A
Try another channel. The problem may be with the broadcast.
A
Are the video cables installed properly?
A
Activate any function to restore the brightness of the picture.
A
Check for local interference such as an electrical appliance or power tool.
A
Station or cable channel experiencing problems, tune to another station.
A
Station signal is weak, reposition the antenna to receive weaker stations.
A
Check for sources of possible interference.
A
Check antenna (Change the position of the antenna).
A
Check HDMI cable over version 1.3.
A
If the HDMI cables don't support HDMI version 1.3, it can cause flickers or no
screen display. In this case use the latest cables that support HDMI version 1.3.
17
Publicidad
