Publicidad
Idiomas disponibles
Idiomas disponibles
3. Connect the quick connector on the other end of the
10 ft (3.0 m) PVC flexible gas supply hose to the rigid Natural
gas supply pipe. To use the quick connect fitting; pull the
head of the quick connect back, insert the end of the PVC
gas hose and release the head of the connector. Check the
the connection is secure.
D
C
A. Manifold
B. Right side panel
C. Natural gas pressure regulator/hose assembly
D. 10 ft. (3.0 m) PVC gas hose
Change Grill Burner Valve Orifices
1. Remove the grates and flame tamers.
2. Remove the screw and clip that hold the burner in place. Set
the screw and clip aside. Remove the burner from the grill by
lifting the burner out.
12
A
B
A
A. Screw
B. Clip
3. Use a 6 mm socket and wrench or 6 mm nut driver to remove
the brass orifice from the end of gas valve. The main burner
orifice is located behind the LP orifice, so no additional orifice
needs to be installed.
IMPORTANT: Check that the orifice is properly installed
inside of the burner opening.
4. Reinsert the burner and reattach using the screw and clip
previously removed. Repeat the procedure for each main
burner.
5. Position the igniters so they are ¼" (6.0 mm) away from each
burner.
Change the Sear Burner Orifices
1. Remove the screw securing the igniter and the 2 searing side
burner screws.
B
A
A. Main burner orifice
Publicidad
