Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
Excessive Weight Hazard
Use two or more people to move and install grill.
Failure to do so can result in back or other injury.
Unpack Grill
1. Remove all packaging materials and remove grill from the
shipping base.
2. Move grill close to desired outdoor location.
3. Open the grill hood.
Remove Packaging Material Inside the Grill
1. Use a utility knife to cut yellow straps and packing tape to
open box from top and remove the boxes.
2. Remove the package on the side burner.
3. Remove foam block and wrap from inside the grill.
4. Replace the grill grates.
5. Place warming shelf on brackets as shown.
A
A. Warming shelf brackets
B. Warming shelf
Attach Left Side Shelf
6. Loosen the 2 screws on the grill side panel and align the
bottom keyhole slots on the side shelf with the loosened
screws. Hook the side shelf onto the two loosened screws
and let the side shelf slide down so the screws are in the
narrow neck of the slots.
8
INSTALLATION INSTRUCTIONS
Freestanding Outdoor Grill Installation
B
IMPORTANT: This step is meant to help with the installation,
but do not depend solely on the two screws to hold the
weight of the sear burner.
7. Attach the top of the side shelf to the grill (B) by inserting
3 screws into the side shelf from inside the grill hood and
tighten.
8. Attach the bottom of the side shelf to the side panel (A) of the
grill by tightening the 2 screws inserted in the keyhole slots in
Step 6.
9. Attach the side shelf to the control panel (C) by tightening the
screw from the side shelf control panel to the main control
panel.
A
10. Make sure that the push bar screw cover is separated from
the screw plate.
B
C
Publicidad
