ADVANCE PLANNING
CAUTION
Due to excessive weight, TWO PEOPLE ARE REQUIRED TO MOVE AND INSTALL THIS Ice
maker. Failure to do so can result in back or other injury.
Cutout & Product Dimensions
*Reference dimension.
Assumes front of door
without exterior panel
aligns with front of
cabinet as shown.
24"
cabinet
depth
Counter-top
overhang
Installation Notes
A drain pump is available for this ice machine. The
GEApplianceparts.com or by calling
877-959-8688.
call 800.561.3344.
Built-In Installation:
in the area after the ice machine has been built in,
shims the expected thickness of the floor should be
installed under the unit to keep the machine level with
the planned floor level.
NOTE: The water connection is at the back and adds a
few inches to the cabinet depth.
Installation on a slab:
pump to the appliance and pump the water to the point
of drainage. See Accessories. Pumps will pump up to
8 feet high.
Installation over a crawl space or basement:
a gravity drain or a pump may be used. For pump, see
49-1000610 Rev. 2
Installation Instructions
34-1/2" min.
to 35"
3-7/8"
*3-5/8"
20-3/8"
GEAppliances.ca or
You will need to install a drain
Either
15"
(38.1 cm)
Floor drain
access hole
Stainless exterior
door dimension.
(cutom panel
size may vary)
3/4"
Accessories
machine for a drain/waste receptacle, the drain will
have to be below the floor.
NOTE: When installed in a corner, the door swing may
be limited due to handle contact with the wall or cabinet
face.
A water supply is required. Water supplies vary in the
degree of mineral content. High mineral content water
will require more frequent maintenance. Water filtration
may improve the taste of the ice as well as cut down on
some of the mineral build up.
34-1/8" min.
Adjustable to
34-7/8"
11