Publicidad
Idiomas disponibles
Idiomas disponibles
DOOR SWING (Cont.)
11. Remove any plastic protective covering from the
stainless door panel
(supplied with door panel kit) as shown in the figure
to attach the inner panel to the exterior panel.
Make sure the handle is located on the desired
side.
13. Turn the upper decorative cover 180 degrees
and snap in the lower position. Turn the lower
decorative cover 180 degrees and snap in the
upper position
14. Replace the door gasket and ice scoop.
14
Installation Instructions
15. Remove the upper hinge plate by pushing in and
sliding to the outside and lower hinge plate by
firmly pushing in and down as shown in the figure.
2
opposite side.
17. Replace the door panel by
installing the top and
bottom hinges with
the 4 screws.
1
4
3
Screws
Screws
49-1000610 Rev. 2
Publicidad
