MRA Duke 890 Instrucciones De Montaje página 3

GB
Read this manual carefully and check the parts list for completeness before you begin. We recommend
Number
1 MRA windscreen
1
pair of holders
4
Distance sleeves 3mm
4
O-ring 4.5 X 1.5
4
Plastic washers 12 X 5 x 0.5mm
4
M5 rubber nuts
4
Fillister head screw M5 X 20mm
2
Cheese-head screws M6 X 40mm
2
Nut covers
2
M6 nuts
2
Clamp for 28/32mm handlebars
2
Washers 12 X 6 X 1mm
1
Edge protection strip with clamping sleeves
Fitting the screen to the motorcycle:
1. Place the motorcycle on a flat surface.
2. Assemble the handlebar clamps with spacer sleeves on the handlebars (P 1).
3. Now insert the M6 nut into the clamps from behind (P 2).
4. Assemble the holding plates with the M6x40mm Allen screws and the black washers to the clamps
(P 3).
5. When assembling the holding plates, lightly press the M6 nut into the clamp to allow the screw to
grip the nut and so that the nut cannot fall out to the rear.
6. Tighten the screws only slightly. Align the holding plates in the middle and at the correct angle to the
motorcycle with the help of the MRA windscreen. Apply the rubber nuts to the holding plates (P 4).
7. Ensure that the clamps are not against the speedometer casing.
8. When the holding brackets are correctly aligned, securely tighten the M6x40mm screws and apply
the cover cap to the clamps (P 5).
9. Insert the M5x20mm pan-head screws with the plastic washers into the holes on the MRA screen.
The 3mm distance sleeves are attached onto the pan-head screws from the other side. Secure them
with the 4.5x1.5mm O-ring (P 6).
10. Mount the MRA windscreen onto the holding plates and tighten the screws.
11. Apply the protective edge strip profile as shown in (P 7).
12. Push the clamping sleeves over the ends of the protective edge strip and lightly compress them,
using a pair of pliers to secure the protective edge strip profile.
After installation, check that all of the screws are tight; tighten them up if necessary. Repeat this at
regular intervals. Clean the screen with water, neutral soap and a sponge. Do not use solvents, alcohol or
MRA-Klement GmbH Siemensstr. 6 D-79331 Teningen Tel.: +49 7663 93890 Email: info@mra.de
Thank you for buying a MRA Windshield.
that you have your screen fitted by an authorised workshop.
Article
spirits to clean the screen as they will damage it.
MO UN T IN G IN STR UC T ION S
KTM Duke 890 2019-
Article No..
--- Allen key 3mm
Allen key 5mm
11345
10872
10992
10635
10629
10673
11016
10540
10646
11118
10559
---
3
Required tools