Publicidad
Idiomas disponibles
Idiomas disponibles
EN
2. 3. 2. Setting the end limits
The end limits can be set in any sequence.
Electric screwdriver prohibited: use a manual adjustment tool: 4 mm
or 5/32'' spherical-head hex key.
Tool available in the catalogue; contact Somfy for the part number.
Setting the upper end limit
Press the Λ button on the control point to raise the
motorised product to the upper end limit and turn the
corresponding setting screw to set the required upper
end limit.
Setting the lower end limit
Press the V button on the control point to lower the
motorised product to the lower end limit and turn the
corresponding setting screw to set the required lower end
limit.
2. 4. TIPS AND RECOMMENDATIONS FOR INSTALLATION
2. 4. 1. Questions about the LS 40 ?
Observations
The motorised
product does not
operate.
24
Images not contractually binding
Possible causes
The wiring is incorrect.
The drive is in thermal protection.
The control point is not compatible.
Check the wiring and modify it if necessary.
Wait until the motor cools down.
Check for compatibility and replace the
control point if necessary.
Copyright © 2017 SOMFY ACTIVITES SA. All rights reserved.
Solutions
Publicidad
