Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING! All maintenance operations require
the equipment to be powered down and
locked out for personal safety.
LOCK-OUT/ TAG-OUT PROCEDURES
Ensure that anyone performing any type of
maintenance on this equipment is familiar with and is
adhering to the lock-out/tag-out procedures set forth by
the General OSHA or the State OSHA guidelines.
VISUAL CHECKS
Visual checks should be conducted at least once per month.
1. Keep the machine and surrounding area as clean
as possible, especially near moving components.
2. Check for loose hardware, especially set screws
located in: sprocket hubs, bearing hubs, and flanges.
3. Check for loose cotter pins.
4. Check for dry seals at the bearings.
5. Check for loose electrical connections and for
frayed cords and cables. Replace immediately
any damaged cords and cables.
TURNTABLE BEARING LUBRICATION TAB
If the turntable becomes noisy during operation, the
supporting cam follower bearings under the turntable
top may need replacement. The bearings are sealed
and lubed for life but will require replacement after
several years of regular use. It is necessary to replace
the entire cam follower assembly (bearings and plastic
housing), not just the bearings, should the bearings
become worn.
NOTE: The king post assembly (center bearing)
is also replaced as a unit rather than individual
components when worn.
WARNING! Failure to follow maintenance
procedures will reduce the life of your
turntable and manufacturer's warranty
obligation.
PAGE 4 OF 15
MAINTENANCE
MAINTENANCE SCHEDULE TABLE
Turntable Belt Drive Tension
(For Predator Low Profile Only)
Gear Motor
NOTE: Refer to Electrical and Mechanical
component's Operations Manuals shipped
inside the enclosure for additional
maintenance information.
PART
Check and adjust every three
months.
The gear motor is filled with oil
and sealed, no maintenance is
required.
SCHEDULE
0223 IH-2304
Publicidad
