Publicidad
Idiomas disponibles
Idiomas disponibles
EN
17
TROUBLESHOOTING
PROBLEM
The motor does
not start.
The machine does
not reach high
pressure.
POSSIBLE
SOLUTION
CAUSE
The power button
Set the power
is in the "OFF"
switch to the
(O) position.
"ON" ( | ) posi-
tion.
The power cord is
Connect the power
not plugged in.
cord to the power
supply.
Electrical outlet
Try another elec-
does not supply
trical outlet.
sufficient power.
The circuit breaker
Let it cool, and
is tripped.
start the machine
again.
The power switch
Pull the spray gun
is on, but you do
trigger.
not pull the spray
gun trigger.
The diameter of
Replace with a 1"
garden hose is too
(25 mm) or 5/8"
small.
(16 mm) garden
hose.
Water supply is re-
Check garden hose
stricted.
for kinks, leaks,
and blockage.
The water supply
Open the water
is not sufficient.
supply fully.
Spray tip has not
Install desired
be installed onto
spray tip to end of
the spray wand
wand.
properly.
The water intake
Remove filter and
filter is clogged.
rinse in warm wa-
ter.
English
PROBLEM
The output pres-
sure varies high
and low.
10
POSSIBLE
SOLUTION
CAUSE
The water supply
Open water supply
is not sufficient.
fully. Check gar-
den hose for kinks,
leaks, or blockage.
The pump is draw-
1. Make sure that
ing in air.
the hoses and
fitting are air-
tight.
2. Turn "OFF"
machine.
3. Purge pump
by squeezing
trigger gun un-
til a stead flow
of water
comes out the
spray tip.
The water intake
Remove the filter
filter is clogged.
and Rinse in warm
water.
The supply volt-
Make sure that on-
age is low.
ly the pressure
washer is running
on the circuit.
The gun, hose or
Run distilled vine-
nozzle are calci-
gar through deter-
fied.
gent tank.
Publicidad
