Publicidad
Idiomas disponibles
Idiomas disponibles
• Remote control display
Signal emission symbol
Signal emission impulse
Temperature
Displays the value
temperature
Timer display
Appears when the air
conditioner on/off time is set
Sleep mode display
Appears when the "Sleep"
button is pressed, the
device will work in sleep
mode.
I-FEEL display
Optional
Remote control instructions:
• The remote control uses two AAA alkaline batteries under normal conditions, the batteries last approximately 6
months. Use two new batteries of a similar type (pay attention to the poles when installing).
• When using the remote controller, point the signal transmitter towards the receiver of the indoor unit;
There must be no obstacles between the remote controller and the indoor unit.
Pressing two buttons simultaneously will result in incorrect operation.
Do not use wireless equipment (such as mobile phones) near the indoor unit.
If interference occurs due to this, please turn off the device, unplug the power cord, then plug it back in and turn
it on again after a while.
• Do not place the remote control in direct sunlight or near sources of heat.
Batteries should be removed from equipment before disposal and disposed of safely.
OWNER'S MANUAL
ECO Display
Appears when the ECO
function is activated.
Turbo Display
AUH Display
Optional
Operation mode
selection screen
AUTO
COOL
DRY
HEAT
SWEEP
Fan speed
Auto
High
Half
Low
Fin location
Position of vertical or
oscillating blinds
SILENT display
Optional
Horizontal swing display
Appears when you press
the "H-SWEEP" button
(optional)
Publicidad
