Oster BVLB07-L00 Manual De Instrucciones página 3

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

FITTING A REPLACEMENT PLUG
FOR U.K. AND IRELAND ONLY
If the plug is not suitable for the socket outlets in your home, it can be removed and
replaced by a plug of the correct type. Please refer to "Installation of a plug" below.
Installation of a plug Applicable to U.K. and Ireland.
WARNING - THIS APPLIANCE MUST BE EARTHED.
NOTE: If the terminals in the plug are not marked or if you are unsure or in doubt about
the installation of the plug please contact a qualified electrician. If a 5A 3-pin plug is fitted,
it must be an ASTA approved plug, conforming to BS1363 standard. Replacement 5A
fuses must be BSI or ASTA BS1362 approved.
The wires in the mains lead are coloured as such:
GREEN AND YELLOW - EARTH
BROWN - LIVE
BLUE - NEUTRAL
Please note that the colour of these mains wires may not correspond with the colour
markings that identify the terminals in your plug.
Please proceed as follows:
The wire which is coloured GREEN AND YELLOW must be connected to the terminal
which is marked with the letter "E" or by the earth symbol
or coloured GREEN or
GREEN AND YELLOW.
The BROWN coloured wire must be connected to the terminal, which is marked with the
letter "L" or is coloured RED.
The BLUE coloured wire must be connected to the terminal, which is marked with the
letter "N" or is coloured BLACK.
E n g l i sh - 2

Publicidad

Tabla de contenido
loading

Tabla de contenido