Trust START-LINE SET ACDB-9000AC Manual De Instrucciones página 8

EN
ACDB-9000AC PORTABLE WIRELESS DOORBELL SET
A
LED indicator doorbell
B
Connect button
C
Volume button
D
Melody selection
E
LED indicator push button
F
Push button
Wireless control
The wireless doorbell can be operated wirelessly with
a minimum of 1 and a maximum of 32 Trust Smart
Home transmitters of your choice. For example, you can
play a desired melody using the supplied push button.
In addition, you can also play a melody when movement
is detected and / or when a window or door is opened.
For each Trust Smart Home transmitter you can set
a separate melody to hear exactly whether someone
presses the push button or if a door or window is opened.
1. Remove battery strip from push button
A
Insert a flat screwdriver into the notch at the bottom
of the push button and slide the push button off the
back plate.
B
Open the waterproof rubber by flipping it to reveal
the battery.
C
Remove the plastic battery strip.
D
Close the waterproof rubber and place the push button
back on the back plate.
2. Installing the doorbell batteries
A
Open the doorbell battery compartment by twisting the
bottom open towards the open lock icon.
B
Insert two 1.5V AA alkaline batteries (not included) as
shown. Be sure to pay attention to the correct polarity
of the batteries (place plus and minus on the right side).
C
Place the bottom cover back on the doorbell.
8
Make sure that the line on the bottom of the doorbell
is in line with the open lock icon. Then turn the bottom
side to the closed lock icon.
3. Selecting the desired volume
First press the volume button to set the desired volume
level. There are 4 levels: High, Medium, Low and Off
(LED indication only). This volume level applies to all paired
transmitters. You can change the volume level if desired.
4. Selecting the desired melody
Press the melody button to select 1 of the 6 melodies.
You can set a separate melody for each transmitter
(push button, motion detector, door/window sensor)
by selecting it in advance.
5. Connecting transmitter(s) to the doorbell
A
Press the connect button for 1 second to activate the
learning mode. The learning mode will be active for
10 seconds and the LED indicator on the doorbell will
flash slowly.
B
While the LED indicator is flashing, send an ON signal
with a Trust Smart Home transmitter to pair it to the
doorbell.
C
As soon as the transmitter is paired, the wireless
doorbell will give 2 short beeps. The transmitter, melody
and volume are now paired. The wireless doorbell is
now ready for use. The doorbell can store 32 different
transmitters in its memory. If you want to pair several
transmitters, repeat steps 3 to 5c.
6A. Securing push button with double-sided tape
Determine where to place the push button and attach the
push button with the supplied double-sided tape.