Hilti BX 3-SCT Manual De Instrucciones Original página 21

▶ Keep the grips dry, clean and free from oil and grease.
▶ Never drop the tool.
▶ Do not use the tool in places where there is a risk of fire or explosion unless the tool is specially approved
for this type of use.
Workplace
▶ Keep the workplace tidy. Clear the work zone of objects that could cause injury.
▶ Untidiness in the working area can lead to accidents.
▶ Make sure that the working area is well lit and well ventilated.
Mechanical safety rules
▶ Do not tamper with or modify the tool or parts of it, especially the piston.
▶ Use only fasteners of a type approved for use with the tool.
Thermal safety rules
▶ Do not exceed the recommended maximum fastener driving rate (see the section headed "Technical
data").
▶ If the tool has overheated, allow it to cool down.
▶ Do not dismantle the tool while it is hot. Allow the tool to cool down.
2.4 Careful handling and use of batteries
▶ Observe the special guidelines applicable to the transport, storage and use of lithium-ion batteries.
▶ Do not expose batteries to high temperatures, direct sunlight or fire.
▶ Do not disassemble, crush or incinerate batteries and do not subject them to temperatures over 80 °C
(176 °F).
▶ Do not use or charge batteries that have suffered mechanical impact, have been dropped from a height
or show signs of damage. In this case, always contact your Hilti Service.
▶ If the battery is too hot to touch it may be defective. Put the battery in a place where it is clearly visible
and where there is no risk of fire, at an adequate distance from flammable materials. Allow the battery to
cool down. If it is still too hot to touch after an hour, the battery is faulty. Contact Hilti Service.
3 Description
3.1 Product overview
3.2 Intended use
The product is a hand-held, cordless fastening tool. It is designed for driving fasteners into concrete. Use
only approved fasteners in combination with the corresponding fastener guide.
*2338836*
1
2338836
Fastener guide
@
Fastener guide locking catch
;
Air vents
=
Belt hook
%
Trigger
&
Grip
(
Release buttons (also used to activate the
)
charge status indicator)
Li­ion battery
+
Status indicator
§
On/off button
/
English 17