EINHELL Euro 2200-1 Manual De Instrucciones página 8

Anleitung Euro 2200-1 19.02.2003
GB
Read this manual carefully before putting the compressor into operation!
Technical data
Power supply
Motor rating in kW/h.p.
Compressor speed in rpm
Operating pressure in bar
Pressure vessel volume in litre
Theoretical intake rate in l/min.
Sound power level LWA in dB(A)
Sound pressure level LPA in dB(A)
Machine dimensions in cm
Machine weight in kg
Article No.
Identification No.
The machine is radio-suppressed in accordance with EC Guidelines 82/499 EEC.
The unit is not intended for outdoor operation as per Article 3 of EC Directive 2000/14/EC.
 The above mentioned
Points to note when
certificates have to be
setting up the
presented on request to
compressor
representatives of your factory
inspectorate. In this connection
 Examine the machine for signs
see also the manufacturer's
of transit damage. Report any
certificate „Notes for the user".
damage immediately to the
company which delivered the
Safety instructions for
compressor.
working with
 Before you put the compressor
compressed air and
into operation, check the oil
level in the compressor pump. paint sprayers
 The compressor should be set
up near the working consumer.
Important! Note the pertinent
 Avoid long air lines and long
accident prevent regulations in
supply lines (extensions).
force in your area!
 Make sure the intake air is dry
and dust-free.
Compressors and lines reach
 Do not set up the compressor
high temperatures during
in damp or wet rooms.
operation. Avoid contact! Risk of
 The complete compressor has
burns!
undergone an official prototype
test. The machine can be put
Gases or vapours drawn in by the
into operation without further
compressor have to be kept free
testing by a technical inspector
of constituents that may cause
(e.g. TÜV). It is important to
fire or explosions inside the
keep the supplied factory
compressor.
certificate and test certificate in
a safe place.
When you disconnect the hose
coupling, hold the coupling
element in your hand to prevent
injury from the whiplashing hose.
8
11:29 Uhr Seite 8
EURO 2200-1
230 V ~ 50 Hz
1,5 / 2
2850
8
24
210
97
87
60 x 30 x 64
31
40.072.50
01022
Wear goggles when working with
the blow-out gun. Injuries may
easily result from foreign bodies
and blasted parts.
Never point the blow-out gun at
other persons and never use it to
clean clothes that are still being
worn.
Note the safety
instructions for paint
spraying!
Important! Note the pertinent
accident prevent regulations in
force in your area!
 Never process paints or
solvents with a flash point
below 21°C.
 Never heat paints or solvents.
 It is imperative to use filtering
equipment (face masks) when
processing harmful liquids.
Note also the information
concerning safety precautions
published by the manufacturers
of these liquids.