Publicidad
Idiomas disponibles
Idiomas disponibles
en-us_main.book.book Page 14 Thursday, February 9, 2023 3:20 PM
14 INSTALLATION
WARNING
• Only use a 4-conductor power-supply cord kit
rated 120/240 volts, 50 amperes and marked for
use with ranges with closed-loop connectors or
open spade lugs with upturned ends. The white
middle (neutral) wire of the power cord or 4-wire
conduit has to be connected to the middle post
of the main terminal block. The other two wires
of the power cord or conduit have to be
connected to the outside posts of the main
terminal connection block. The 4th ground wire
(green) must be connected to the frame of the
oven with the ground screw. Failure to do so can
result in electrical shock, severe personal injury
or death.
Cable from home power supply
a
Black wires
b
White wires
c
Red wires
d
Green (or bare) ground wires
e
4-wire flexible conduit from oven
f
1
Separate the oven ground and white wires if
necessary.
2
Connect the oven ground (green) wire to the
branch circuit ground (green) wire in
accordance with local codes, using a wire nut.
3
Connect the oven white wire to the branch
circuit neutral (white or gray) wire in
accordance with local codes, using a wire nut.
4
Connect the oven red wire to the branch
circuit red (L2) wire in accordance with local
codes, using a wire nut.
5
Connect the oven black wire to the branch
circuit black (L1) wire in accordance with local
codes, using a wire nut.
6
Install the junction box cover.
Installing Oven and Assembling
Oven Doors and Bottom Decorative
Trim
Installing the Oven
Install the oven into the cabinet as follows:
1
Use caution when lifting the oven and wear
gloves to protect hands from any sharp
edges.
2
Use two or more people to lift or move the
oven into the cabinet opening.
• Loop (do not tie) a 36" (91 cm) string around
the conduit before the oven is slid into
place. Lay the string over the top of the
oven and use it to keep the conduit from
falling behind the oven.
• Lift the oven into the cabinet cutout using
the oven opening as a grip. Carefully push
against the oven front frame. Do not push
against the outside edges.
• While sliding the oven back, pull the string
so that the conduit lies on the top of the
oven in a natural loop.
• When you are sure the conduit is out of the
way, slide the oven 3/4 of the way back into
the opening. Remove the string by pulling
on one end of the loop.
3
Secure the oven.
• Using the mounting holes
side trim as a guide, drill pilot holes for the
screws provided. (For securing the double
wall oven, use a minimum of 4 screws, one
on each side in both the upper and lower
ovens. For securing the single wall oven,
on the oven
a
Publicidad
