Publicidad
Idiomas disponibles
Idiomas disponibles
en-us_main.book.book Page 15 Thursday, February 9, 2023 3:20 PM
use a minimum of 2 screws, one on each
side.)
• Secure the oven to the cabinet with the
screws provided. If the cabinet is particle
board, you must use 3/4" particle board
screws. These may be purchased at any
hardware store.
Assembling Oven Doors
1
Firmly grasp both sides of the door at the top.
2
With the door at the same angle as the
removal position, seat the indentation
the hinge arms
into the bottom edge of the
a
hinge slots
. The notch in the hinge arms
b
must be fully seated into the bottom edge of
the slots.
3
Open the door fully. If the door will not open
fully, the indentation is not seated correctly in
the bottom edge of the slots.
4
Lock the hinge locks
toward the slots in the oven frame until they
lock.
of
c
, rotating them back
d
5
Close the oven door.
Bottom vent trim
a
NOTE
• When you install the oven door, be carefull not
to bump the bottom vent trim.
• Keep oven vents unobstructed. Replace the
bottom vent trim if it becomes bent or
deformed. Never block the vent with plastic or
heat-sensitive items.
Assembling the Bottom Decorative
Trim
Bottom decorative trim
a
• After installing the oven in the cabinet, assemble
bottom decorative trim with 2 screws
Test the Oven Before Use
Each of the functions has been factory checked
before shipping. However, it is suggested that you
verify the operation of the oven once more. Refer
to the owner's manual and follow the instructions
for the basic check.
• Turn on the power supply. The initial signal
sound is heard and the Clock segment appears
in the display.
NOTE
• Depending on the model, some of the following
functions may not be available.
1
Turn on the power supply. The initial signal
sound will be heard.
INSTALLATION
15
(4X10).
b
Publicidad
