Fein VersaMAG VISE Serie Manual De Instrucciones página 20

en
20
For your safety.
Read all safety warnings and all
WARNING
instructions. Failure to follow the
warnings and instructions may result in serious injury.
Save all safety warnings and instructions for future ref-
erence.
Do not use this product before you have thor-
oughly read and completely understood this
Instruction Manual. The documents mentioned
should be kept for later use and enclosed with the
product, should it be passed on or sold.
Please also observe the relevant national industrial
safety regulations.
Intended use.
Permanent magnet with vise for:
– clamping of various materials for machining with
hand-guided tools and drill presses
– positioning on magnetizable, clean, rust-free, coat-
ing-free and ice-free flat materials of 4 mm thickness
upward
in workshops and mobile on construction sites in
weather-protected environments using the attach-
ments and accessories developed and recommended by
FEIN. Use only with firm footing.
All other types of use are considered as not intended
for.
This product is not intended for continuous everyday
use.
The operator is solely liable for any damage caused by
use not as intended for.
Foreseeable improper use
For safe operation of the product and to exclude mis-
use, the following is prohibited:
– Unauthorized modifications
– Drilling holes in the product and the permanent
magnet
– Improper use, particularly (but not exclusively) for:
— use of non-approved attachments,
— use as a lifting magnet,
— use as a step or a handle to assist climbing,
— use in machine tools such as milling machines.
– Non-observance of the operating instructions.
Special safety instructions.
Keep work area clean and well lit. Cluttered or dark
work areas invite accidents.
Dress properly. Do not wear loose clothing or jewellery.
Keep your hair, clothing and gloves away from moving
parts. Loose clothes, jewellery or long hair can be
caught in moving parts.
Always secure the Product with the supplied safety
strap. Keep bystanders away while using the product.
Always clamp workpieces with sufficient clamping
force. A workpiece not securely fastened can come
loose and cause injuries.
The spindle of the vise must not be driven with electric
tools.
Keep the magnet away from persons with cardiac pace-
makers.
Use the magnet only at an ambient temperature
between –15 °C and +45 °C.
Do not rivet or screw any name-plates or signs onto the
product. This can result in damage to the magnets.
Do not use accessories that have not been especially
developed or approved by FEIN.
Transport.
Air freight
Magnetic fields from improperly packaged magnets
could affect aircraft navigation equipment. In the worst
case, this can lead to an accident.
For air transport, only dispatch magnets in packaging
with sufficient magnetic shielding.
Observe the relevant regulations.
Starting Operation.
Before carrying out any work with the product, check
that the clamping screws are tight.
Keep bystanders away while using the product.
Operating Instructions.
Use personal protective equipment according to the
application.
Use the magnet only on magnetic surfaces with a wall
thickness of at least 4 mm.
Pay attention that the set-up surface for the magnetic
foot is flat, clean, rust-free and ice-free. Remove var-
nish, putty/filler layers and other materials. Prevent an
air gap between the magnetic foot and the set-up sur-
face. The air gap reduces the magnetic holding power.
Do not use this product on hot surfaces > 80 °C, as this
will result in a permanent reduction of the magnet
holding power.
Switching the magnet on.
Clamp and machine workpieces only when the lever
position is at ON.