Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: Mirror will extend 2¼" above mounting
bracket and 2" below bracket. (See Figure 3)
Figure 3
Half Mirror
Width
3. Drill holes in wall at marked locations. Insert wall
anchors. (See Figure 4)
Figure 4
4. Hold bracket over drilled holes and insert screws.
Tighten using a Phillips screwdriver. (See Figure 5)
Figure 5
PAGE 2 OF 6
INSTALLATION CONTINUED
5. Carefully slide mirror down onto the bracket,
2¼"
2"
6. Try lifting mirror after installation. Unit was correctly
1-800-295-5510
uline.com
ensuring it locks into bracket tabs. (See Figure 6)
Figure 6
installed if it does not slide off.
NOTE: If looking to replace or remove mirror,
call Uline Customer Service at 1-800-295-5510
to order the H-9526 removal tool.
IMPORTANT!
• Adequate in-wall backing must be provided
by installer to fully support weight of unit.
Always check local codes and ordinances
prior to installation.
• Use extreme care when removing wall
bracket from back of mirror. Do not allow
tabs or slots to become flat or bent out of
shape.
• Ensure slots on back of mirror slide over all
the wall bracket tabs. When mirror is secured
to wall, a concealed locking tab will audibly
snap into locking position.
• If mirror lifts off wall, check for damaged
tabs or slots.
• Mirrors are not interchangeable from
horizontal to vertical, or vice versa.
Mirror
Mounting
Bracket
Tab
0623 IH-9523
Publicidad
