Descargar Imprimir esta página

Normatec 3 Instrucciones Originales página 12

Ocultar thumbs Ver también para 3:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 74
Voltage dips
and short
interruptions
on AC mains
input lines (IEC
61000-4-11)
Conducted
RF RF coupled
into lines (IEC
61000-4-6)
Radiated RF
(IEC 61000-4-3)
EQUIPMENT CLASSIFICATION
• Protection against electric shock: Class II/internally powered equipment
• Degree of protection against electric shock: Type BF applied part (control unit, leg,
arm, and hip attachments)
• Ingress protection: IP21
• Equipment not suitable for use in the presence of a flammable anesthetic mixture
with air or with oxygen or nitrous oxide
• Continuous operation
TROUBLESHOOTING
Problem
The system
does not start
The attachments
(leg, arm, or hip)
do not inflate
The system
stopped
pumping
Air leak
message: ERR
Low Battery
Cannot establish
or maintain
a Bluetooth
connection
Call Hyperice customer service at +1.949.565.4994 if further assistance is needed.
0.5 cycles 1 cycle
25 cycles (50 Hz)
30 cycles (60 Hz)
250 cycles (50
Hz) 300 cycles
(60 Hz)
3 Vrms
150 kHz to
80 MHz
6 Vrms in ISM
bands
10 V/m
80 MHz to
2.7 GHz
Possible Causes
Power is not turned on
Charger is not securely
connected Faulty
electrical wall outlet
The session has not
been started The
hose is not securely
connected The
attachments or hose
have been damaged
The hose is not
securely connected
The attachments have
been damaged
Air leak
Battery needs to be
charged
Bluetooth is turned off
Mains power should be that of a typical clinic,
hospital, athletic training, or home environment.
If you require continued operation during power
mains interruptions, ensure that batteries are
installed and charged. Ensure that battery life
exceeds longest anticipated power outages or
provide additional uninterruptible power source.
This device is suitable for the electromagnetic
environment of typical clinic, hospital, athletic
training or home environments.
Solutions
Press the power button to turn the control
unit on.
Check that the battery is charged or that
the charger is securely connected to the
Normatec 3 control unit and the electrical
outlet. Check that the wall outlet works.
Tap the start button to start the session.
Check that the hose is securely connected
to the Normatec 3 control unit and that the
attachments are securely connected to the
junction box. Check that the attachments
and/or hose do not have an air leak.
Check that the hose is securely connected
to the Normatec 3 control unit and that the
attachments are securely connected to the
junction box. Check that the attachments
do not have an air leak.
Check for leaks in the hose or attachment.
Check that the connectors are firmly
connected. if using only one attachment,
make sure blocking plug is fully seated in
junction box.
Plug in the control unit to charge the battery.
Turn on Bluetooth on both the Normatec 3
control unit and the phone attempting to
pair with the Normatec 3 control unit.

Publicidad

loading