Before Use; Prior To Operation - Metabo HPT DH 18DBL Manual De Instrucciones

English
● Since the built-in micro computer takes about
3 seconds to confi rm that the battery being
charged with charger is taken out, wait for a
minimum of 3 seconds before reinserting it to
continue charging. If the battery is reinserted
within 3 seconds, the battery may not be properly
charged.
● If the pilot lamp does not blink in red (every
second) even though the charger cord is
connected to the power, it indicates that
the protection circuit of the charger may be
activated.
Remove the cord or plug from the power and
then connect it again after 30 seconds or so. If
this does not cause the pilot lamp to blink in red
(every second), please take the charger to the
metabo HPT Authorized Service Center.

BEFORE USE

Check the work area to make sure that it is clear of debris
and clutter.
Clear the area of unnecessary personnel. Ensure that
lighting and ventilation is adequate.

PRIOR TO OPERATION

1. Confi rming condition of the environment
Confi rm that the work site is placed under appropriate
conditions conforming to prescribed precautions.
2. Attaching the side handle (Fig. 6)
(1) Turn the grip of the side handle to loosen it and push it
in until it comes in contact with the housing.
(2) Adjust the side handle to the angle that allows the
easiest use, then turn the side handle's grip fi rmly to
lock it place.
Loosen
12
Tighten
Fig. 6
3. Mounting the drill bit (Fig. 7,8)
CAUTION
To prevent accidents, make sure to turn the
switch off .
NOTE
When using tools such as drill bits, etc., make sure to
use the genuine parts designated by our company.
(1) Clean the shank portion of the drill bit.
(2) Insert the drill bit in a twisting manner into the tool
holder until it latches itself. (Fig. 7)
The grip need not be adjusted during bit installation.
Front cap
Part of SDS-plus shank
Drill bit
(3) Check the latching by pulling on the drill bit.
(4) To remove the drill bit, fully pull the grip in the direction
of the arrow and pull out the drill bit. (Fig. 8)
Drill bit
4. Installation of dust cup or dust collector (B) (Optional
accessories) (Fig. 9, Fig. 10)
When using a rotary hammer for upward drilling
operations attach a dust cup or a dust collector (B)
to collect dust or particles for easy operation.
○ Installing the dust cup
Use the dust cup by attaching to the drill bit as shown
in Fig. 9.
When using a bit which has big diameter, enlarge the
center hole of the dust cup with this rotary hammer.
○ Installing dust collector (B)
When using dust collector (B), insert dust collector (B)
from the tip of the bit by aligning it to the groove on the
grip. (Fig. 10)
Grip
Fig. 7
Grip
Fig. 8