How To Use - Metabo HPT DH 26PC Manual De Instrucciones E Instrucciones De Seguridad

(4) To remove the drill bit, fully pull the grip in the direction
of the arrow and pull out the drill bit. (Fig. 3)
Drill bit
Fig. 3
7. Installation of dust cup or dust collector (B) (Optional
accessories) (Fig. 4, Fig. 5)
When using a rotary hammer for upward drilling
operations attach a dust cup or dust collector (B) to
collect dust or particles for easy operation.
Installing the dust cup
Use the dust cup by attaching to the drill bit a shown in
Fig. 4.
When using a bit which has big diameter, enlarge the
center hole of the dust cup with this rotary hammer.
Dust cup
Fig. 4
Installing dust collector (B)
When using dust collector (B), insert dust collector (B)
from the tip of the bit by aligning it to the groove on the
grip (Fig. 5)
Dust collector (B)
Grip
Fig. 5
CAUTION
The dust cup and dust collector (B) are for
exclusive use of concrete drilling work. Do not
use them for wood or metal drilling work.
Insert dust collector (B) completely into the chuck
part of the main unit.
When turning the rotary hammer on while dust
collector (B) is detached from a concrete surface,
dust collector (B) will rotate together with the drill
bit. Make sure to turn on the switch after pressing
dust cup on the concrete surface. (When using
000Book_DH26PC_NA_metabo.indb 9 000Book_DH26PC_NA_metabo.indb 9
Grip
8.
9.

HOW TO USE

1.
dust collector (B) attached to a drill bit that has
more than 7-15/32" (190 mm) of overall length,
dust collector (B) cannot touch the concrete
surface and will rotate. Therefore please use
dust collector (B) by attaching to drill bits which
have 6-17/32" (166 mm), 6-19/64" (160 mm) and
4-21/64" (110 mm) overall length.)
Dump particles after every two or three holes when
drilling.
Please replace the drill bit after removing dust
collector (B).
Selecting the driver bit
Screw heads or bits will be damaged unless a bit
appropriate for the screw diameter is employed to drive
in the screws.
Confi rm the direction of bit rotation (Fig. 6)
The bit rotates clockwise (viewed from the rear side) by
pushing the R-side of the push button. The L-side of the
push button is pushed to turn the bit counterclockwise.
Push
button
Fig. 6
CAUTION
To prevent accidents, make sure to turn the switch
o and disconnect the plug from the receptacle
when the drill bits and other various parts are
installed or removed. The power switch should
also be turned o during a work break and after
work.
Switch operation
The rotation speed of the drill bit can be controlled
steplessly by varying the amount that the trigger
switch is pulled. Speed is low when the trigger switch
is pulled slightly and increases as the switch is pulled
more. To turn the switch OFF, release the trigger
switch to its original position. However, the switch
trigger can only be pulled in halfway during reverse and
rotates at half the speed of forward operation.
Pulling the trigger and pushing the stopper, it keeps
the switched-on condition which is convenient for
continuous running. When switching o , the stopper
can be disconnected by pulling the trigger again. The
switch stopper is unusable during reverse.
English
9
2018/03/22 9:55:31 2018/03/22 9:55:31