Stihl KM 85 Manual De Instrucciones página 15

english / USA
4
3
5
6
7
:
Place the clamp (3) in the loop
handle (4) and position them both
against the drive tube (5).
:
Fit the clamp (6) and place the
barrier bar (2) in position.
Note correct position.
: Line up the holes.
: Insert screws (7) in holes and screw
them into the barrier bar as far as
stop.
:
Go to "Securing the loop handle".
14
2
Loop handle without barrier bar
:
Place the clamp (3) in the loop
handle (4) and position them both
against the drive tube (5).
:
Fit the clamp (6) and line up the
holes.
: Fit washers (7) on screws (8).
: Insert screws (8) in holes and screw
on the square nuts (1) as far as
stop.
:
Go to "Securing the loop handle".
8
8
7
7
4
3
5
6
1
1
A
9
10
Securing the loop handle
:
Secure the loop handle (4)
approx. 8"/20cm (A) forward of
the control handle (9).
:
Line up the loop handle.
:
Tighten down the screws firmly -
lock the nuts if necessary.
10 Sleeve*
* see "Guide to Using this Manual"
KM 85, KM 85 R
4