Preparing For Use; Electrical Connections - DeLonghi PAC CN120E Instrucciones De Uso

DESCRIPTION
1 Air outlet grille
2
Control panel
3 Handles
4
Castors
5 Filter
6 Evaporator air intake grille
7 Air exhaust hose housing
8 Condenser air intake grille
9 Power cable
10 Drainage hose with 2 caps
11 Wall flange with cap
12 Air exhaust hose
13 Hose adaptor
14 Accessory for wall mounting
15 Window bracket
16 Additional window bracket
17 Window outlet
18 Remote control

ELECTRICAL CONNECTIONS

Before plugging the appliance into the mains socket, check
that:
• The outlet's power supply corresponds to the value
indicated on the rating label on the back of the appliance;
• The outlet and electrical circuit are adequate for the
appliance;
• The outlet is a 3-hole grounded outlet . If this is not
the case, you must choose another outlet.
Failure to follow these important safety instructions
absolves the manufacturer of all liability.
The power cable must be replaced by a qualified
professional only.
The instructions below will enable you to prepare your air
conditioner for operation as efficiently as possible. Before
use, make sure the air intake and outlet grilles are
unobstructed.
NOTE: This appliance is provided with and auto-evaporation
feature for condensate removal during cooling and
dehumidifing modes.
AIR-CONDITIONING WITH INSTALLATION
Just a few simple steps and your comfort is ensured with your
air conditioner.
For optimal results set-up your appliance as follows:
• Screw the hose adaptor 13 to the hose's end 12.
• Fit the air exhaust hose in the housing at the back of the

Preparing for use

appliance. Insert it as shown in figure A.
A
• Install the appliance respecting the distances given in fig.
B.
B
30 cm
12 inches
Proceed as follows:
• Drill a hole (ø134mm / 5,27 in.) in an outside wall or
through a window pane.
Respect the height and dimensions of the hole given in
figures B and C.
NOTE: As special tools are required for installation, we suggest
you have the appliance installed by specialized personnel.
C
in the window pane in the wooden
kickboard of a
French window
5
en
30 cm
12 inches
in the wall: you are
recommended to
insulate the section
of wall using suitable
insulation.