ELECTRICAL CONNECTIONS
Before plugging the appliance into the the electrical receptacle,
check that:
•
The outlet's power supply corresponds to the value
indicated on the rating label on the back of the appliance;
•
The outlet and electrical circuit are adequate for the
appliance;
•
The outlet is a 3-hole grounded outlet . If this is not
the case, you must choose another outlet.
Failure to follow these important safety instructions
absolves the manufacturer of all liability.
The power cable must be replaced by a qualified
professional only.
The instructions below will enable you to prepare your air
conditioner for operation as efficiently as possible.
Before use, make sure the air intake and outlet grilles
are unobstructed.
NOTE:
This appliance is provided with an auto-evaporation
feature for condensate removal during cooling and
dehumidifing modes.
SEMI-PERMANENT INSTALLATION
Just a few simple steps and your comfort is ensured with your
air conditioner:
•
Screw the hose adaptor 13 to the hose's end 12.
•
Fit the air exhaust hose in the housing at the back of the
appliance. Insert it as shown in figure A.
A
If required, your appliance can also be installed semi-
permanently (Fig. B).
Preparing for use
B
Proceed as follows:
•
Drill a hole (ø134mm / 5.27 in.) in an outside wall or
through a window pane.
Respect the height and dimensions of the hole given in
figures B and C.
NOTE: As special tools are required for installation, we suggest
you have the appliance installed by specialized personnel.
KEEP THE AIR HOSES AS SHORT AND FREE OF CURVES AS
POSSIBLE TO AVOID CONSTRICTIONS.
in the window pane in the wooden
kickboard of a
C
French window
•
Fit the wall flange 11 into the hole.
•
Screw the hose adaptor 13 to the hose's end 12.
•
Fit the air exhaust hose in the housing at the back of the
appliance as shown in figure A.
•
Screw the wall mounting accessory 14 into the hose 12
(fig. D) and fit it into the wall flange 11 as shown in fig. E.
D
5
en
in the wall: you are
recommended to insulate
the section of wall using
suitable insulation.
2