Publicidad
Idiomas disponibles
Idiomas disponibles
Electric Handle
Heating*
Switching on electric handle heating*
:
Move switch on front handle to I –
move switch back to 0 to switch off
the heating.
There is no risk of overheating during
long periods of operation. The whole
heating system is maintenance-free.
*
see "Guide to Using this Manual"
MS 360
Information
Before You Start
STOP
0
The four positions of the
Master Control lever
To start the engine, move the lever to the
cold start position l (1) - do not use
force.
If the Master Control lever is in the run
position (3): Press down the throttle
trigger interlock and move the Master
Control downward.
Cold start position:
Choke shutter is closed – throttle trigger
is in starting-throttle position. This
position is used to start a cold engine.
As soon as the engine begins to fire,
move the Master Control lever one
notch upward to the warm start
4
position n (2).
Warm start position:
Choke shutter is open – throttle trigger
is in starting-throttle position. If you
3
leave the Master Control lever in the
cold start position, the combustion
2
chamber will flood and stall the engine.
The Master Control lever must be in the
1
warm start position (2) to start a warm
engine. Also select this position if the
engine has been running but is still cold.
The Master Control lever is locked and
can only be moved to the run position (3)
after squeezing the throttle trigger - do
not use force.
english
35
Publicidad
