Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
WARNING
To reduce the risk of injury, use only
identical replacement parts recom-
mended by the manufacturer. Tool
service must be performed only by
qualifi ed repair personnel. Always
wear safety goggles or glasses with
side shields when servicing tools.
Disconnect tool from air supply be-
fore servicing.
Cleaning
Clean dust and debris from tool vents.
Keep tool handles clean, dry and free of oil
or grease. Use only mild soap and a damp
cloth to clean the tool, since certain cleaning
agents and solvents are harmful to plastics
and other parts. Some of these include gaso-
line, turpentine, lacquer thinner, paint thinner,
chlorinated cleaning solvents, ammonia and
household detergents containing ammonia.
Never use fl ammable or combustible sol-
vents around tools.
Cold Weather Operation
For cold weather operation, near and below
freezing, the moisture in the air line may
freeze and prevent tool operation. Use an
air tool lubricant or permanent antifreeze as
a cold weather lubricant in the air line.
Do not store tools in a below-freezing envi-
ronment. Ice or frost could form on the tools'
operating valves and mechanisms, causing
tool failure.
Air Supply-Pressure and Volume
Air volume is as important as air pressure.
The air volume supplied to the tool may be in-
adequate because of undersized fi ttings and
hoses, or from the effects of dirt and water in
the system. Restricted air fl ow will prevent
the tool from receiving an adequate volume
of air, even though the pressure reading is
high. The results will be slow operation or
reduced driving power. Before evaluating tool
problems for these symptoms, trace the air
supply from the tool to the supply source for
restrictive connectors, low points containing
water and anything else that would prevent
full volume fl ow of air to the tool.
14
FIVE YEAR TOOL
LIMITED WARRANTY
Every MILWAUKEE tool is tested before leaving
the factory and is warranted to be free from defects
in material and workmanship. MILWAUKEE will
repair or replace (at MILWAUKEE's discretion),
without charge, any tool (including battery char-
gers) which examination proves to be defective
in material or workmanship for fi ve (5) years after
the date of purchase. Return the tool and a copy
of the purchase receipt or other proof of purchase
to a MILWAUKEE Factory Service/Sales Support
Branch location or MILWAUKEE Authorized
Service Station, freight prepaid and insured. This
warranty does not cover damage from repairs
made or attempted by other than MILWAUKEE
authorized personnel, misuse, alterations, abuse,
normal wear and tear, lack of maintenance, or ac-
cidents. Certain parts of certain tools, such as but
not limited to o-rings, seals, bumpers, and driver
blades for MILWAUKEE nailers and stapling tools,
are considered normal wear and tear items not
covered by this warranty.
The warranty period for Li-Ion Battery Packs is two
(2) years from the date of purchase. The warranty
period for Ni-Cd Battery Packs, Flashlights, Radios,
and Professional Hoists (lever, chain, and electric)
is one (1) year from the date of purchase.
THE REPAIR AND REPLACEMENT REMEDIES
DESCRIBED HEREIN ARE EXCLUSIVE. IN NO
EVENT SHALL MILWAUKEE BE LIABLE FOR ANY
INCIDENTAL, SPECIAL, OR CONSEQUENTIAL
DAMAGES OR FOR ANY EXPENSES, LOSSES
OR DELAYS INCIDENTAL TO ANY DAMAGE TO,
FAILURE OF, OR DEFECT IN ANY PRODUCT,
INCLUDING BUT NOT LIMITED TO LOSS OF
PROFITS.
THIS WARRANTY IS EXCLUSIVE AND IN LIEU
OF ALL OTHER WARRANTIES, OR CONDITIONS,
WRITTEN OR ORAL, EXPRESS OR IMPLIED.
WITHOUT LIMITING THE GENERALITY OF
THE FOREGOING, MILWAUKEE DISCLAIMS
ANY IMPLIED WARRANTY OF MERCHANT-
ABILITY OR FITNESS FOR A PARTICULAR
USE OR PURPOSE AND ALL OTHER IMPLIED
WARRANTIES.
This warranty gives you specifi c legal rights. You
may also have other rights that vary from state to
state and province to province. In those states that
do not allow the exclusion of implied warranties or
limitation of incidental or consequential damages,
the above limitations or exclusions may not apply
to you. This warranty applies to the United States,
Canada, and Mexico only.
ACCESSORIES
WARNING
Always disconnect the air supply
from the tool and remove fastener
strips before changing or removing
accessories. Only use accessories
specifi cally recommended for this
tool. Others may be hazardous.
For a complete listing of accessories refer to
your MILWAUKEE Electric Tool catalog or go
on-line to www.milwaukeetool.com. To obtain
a catalog, contact your local distributor or a
service center.
Use MILWAUKEE fasteners with the
following specifi cations:
Length: 0.625" to 2.125"
Collation Angle: 0°
Size: 18 gauge
Quick Connectors
15
Publicidad
