Publicidad
Idiomas disponibles
Idiomas disponibles
This Manual is Designed to Make it as Easy as Possible for You
to Assemble, Install, Operate, and Maintain Your Ceiling Fan
Tools Needed for Assembly
• One Phillips head screwdriver
• One stepladder
• One ¼˝ blade screwdriver
▲WARNING
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 4). If you feel you
do not have enough wiring knowledge or experience,
have your fan installed by a licensed electrician.
For your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all
▲WARNING
Do not install or use fan if any part is damaged or
missing. This product is designed to use only those
parts supplied with this product and/or any accessories
designated specifically for use with this product by
Fanimation. Substitution of parts or accessories not
designated for use with this product by Fanimation could
result in personal injury or property damage. Contact
your retail store for missing or damaged parts.
1. Check to see that you have received the following
parts:
NOTE: If you are uncertain of part description, refer to
exploded view illustration. (Figure 1, page 14)
Ceiling Plate Assembly
Motor Assembly
Support Rod-Short
• One wire stripper
• Three wire connectors
(supplied)
Unpacking Instructions
Blade Holder With Blade
Assembly
Blade Holder Cover
assembly
Support Rod-Middle
Materials
Wiring outlet box and box connectors must be of type
required by local code. The minimum wire would be a 3-
conductor (2-wire with ground) of the following size:
Installed Wire Length
Up to 50 ft.
50 - 100 ft.
NOTE: Place the parts from the loose parts bags in a small
container to keep them from being lost. If any parts are missing,
contact your local retailer.
• Motor Assembly
• Ceiling Plate Assembly
• Support Rod-Long
• Support Rod-Middle
• Support Rod-Short
• Blade Holder With Blade
Assembly
• Blade Holder Cover assembly
• Remote Hand Held (TR33WH)
Support Rod-Long
3
Wire Size A.W.G.
14
12
• Hardware bags:
– Four Wire Connectors
– Four 3/16-24x14mm Screw
– " L " Allen Wrench
– Two Hex Nut 1/8-27x10mm
– Two 1/8 Lockwasher
– Two Clip Clevis
– Hex Wrench
Phillips Screwdriver
˝
– 4
Remote Hand Held
TR33WH
Hardware bag
Publicidad
