Other Functions; Using The Rotary Commander - Sony XR-C7200W Manual De Instrucciones

Other Functions

Using the rotary
commander
The rotary commander works by pressing
buttons and/or rotating controls.
You can control the optional CD and MD
changer with the rotary commander.
By pressing the button
(the SOURCE button)
(SOURCE)
EN
Each time you press (SOURCE), the source
changes as follows:
Tuner n CD n MD n Tape
Pressing (MODE) changes the operation in
the following ways
• the tape transport direction
• the band: FM1 n FM2 n MW n SW 1 n
SW 2
• the CD unit: CD1 n CD2 n ....
• the MD unit: MD1 n MD2 n ....
Tip
You can turn on this unit by pressing (SOURCE) on the
rotary commander.
By rotating the control
(the SEEK/AMS control)
Rotate the control momentarily and
release it to:
•Locate the beginnings of the tracks on the
tape. Rotate and hold the control, and
release it to fast-wind the tape. To
playback, rotate and hold the control
again, and release it.
•Locate a specific track on a disc. Rotate
and hold the control until you locate the
specific point in a track, then release it to
10
start playback.
• Tune in stations automatically. Rotate and
hold the control to tune in the specific
station.
By rotating the control while
pushing in (the PRESET/DISC
control)
Push in and rotate the control to:
• Receive the stations memorized on the
preset buttons.
• Change the disc.
Other operations
Rotate the VOL control to
adjust the volume.
(MODE)
Changing the operative direction
The operative direction of controls is factory
preset as in the illustration below.
If you need to mount the rotary commander on
the right of the steering column, you can
reverse the operative direction of the controls.
Press (LIST) to display
memorized names.
To increase
To decrease
Press (MUTE) to
mute the sound.
Press (OFF) to
turn off the
unit.
Press (SOUND) to
adjust the volume
and sound menu.